![]() |
|
|||||||
| Farmers Lab Advanced Theories and Techniques - Got a few grows under your belt and want to discuss more advanced theories and techniques? Discuss these matters here. |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#23 (permalink) |
|
YaHookan
Join Date: Feb 2006
Location: Idaho, USA
Posts: 137
Thanks: 1
Thanked 3 Times in 2 Posts
|
There is two 30 watt daylight bulbs and two 42 watt soft white bulbs. I'm using black magic soil and theres a small cpu fan in the back. Any input? anything you guys think i should do or change?
|
|
|
|
|
|
#24 (permalink) | |
|
Der Bongmeißter
Join Date: Oct 2006
Location: Aquarium
Posts: 1,369
Thanks: 0
Thanked 2 Times in 2 Posts
|
Quote:
Dont overwater, dont overfertilize, and ya should be good to go for at least another month. |
|
|
|
|
|
|
#28 (permalink) |
|
Der Bongmeißter
Join Date: Oct 2006
Location: Aquarium
Posts: 1,369
Thanks: 0
Thanked 2 Times in 2 Posts
|
A cheap hood for your hoodless CFTs
I see in this picture that some of your fixtures dont have reflectors. hehehe... you can almost double the light getting to the plants. Here's how to make a cheap hood for CFTs.
This ONLY works for CFTs < 100W (total). Other HID lights WILL cause fire hazards and hot spots! Make sure there is NO exposed wiring on fixture! Take a breakfast cereal, ritz cracker, or whatever cardboard box apart carefully at the glue lines. Flatten it out. You'll end up with a largish rectangle of cardboard thats about as wide as most rolls of aluminum foil. Roll the aluminum foil - dull side out (athough it doesn't really matter with CFTs) - over the cardboard. Crimp the foil over the ends and tape down. Cut a hole big enough to slide your electric cable - but not the fixture! - through right in the middle. Bend into a semicircle, like a quonset hut, hangar, or corrugated metal building. Use duct tape to tape the sides together at the ends, and the middle. (I put CDs on the ends, as well) Slide your cable through the hole. Hang. Voilá! ![]() The aluminum will act as a "heat sink" for the ballasts (the big white heavy non-light part) or the tubes if the hood happens to be sitting directly on them. There is NO danger of the cardboard reaching ignition temperature. If a fire happens, it'd be due to other causes, not the cardboard catching on fire from resting on the light. I also have several flat "panels" made this way that I used to use in the stepladder "growroom" during veg. The neat thing about CFTs is that "hot spots" are damn near imposible to get; you'd almost have to make a parabolic reflector and set the plant at the focus. |
|
|
|
|
|
#29 (permalink) |
|
YaHookan
Join Date: Feb 2006
Location: Idaho, USA
Posts: 137
Thanks: 1
Thanked 3 Times in 2 Posts
|
the top is close enogh that I dont think it matters all that much. Even if it does im too lazy to do that. and bluefoot fuck you I didnt forget I thought my friend had it under control.
|
|
|
|
|
|
#31 (permalink) |
|
YaHookan
Join Date: Feb 2006
Location: Idaho, USA
Posts: 137
Thanks: 1
Thanked 3 Times in 2 Posts
|
The plants have been doing better now but are tiny for being a month old. One still loks like a seedling and the other isnt much bigger. The biggest problem was root rot and then freezing temps, and a little bit of underwatering. Now its all fixed and i cant wait for them to show it. Heres the biggest
|
|
|
|
|
|
#33 (permalink) |
|
YaHookan
Join Date: May 2006
Posts: 729
Thanks: 81
Thanked 73 Times in 52 Posts
|
Holy shit, i was going to ask the same question here. I have a crawlspace under my basement too that is like dirt and I was just thinking I wonder if I could grow down there.. but its winter and snowing in Co and it gets coold.. I really dont want a heater down there cause it could pottentially start a fire ..
|
|
|
|
|
|
#36 (permalink) | |
|
Old School
Join Date: Nov 2006
Posts: 118
Thanks: 3
Thanked 1 Time in 1 Post
|
Quote:
http://www.yahooka.com/forum/showthr...=116794&page=3 Whats all those white stuff all over my spindly little plants? Should I scrape it all off?
__________________
I reject your reality and substitute my own Last edited by jonro37; 01-04-2007 at 06:25 AM. |
|
|
|
|
|
|
#37 (permalink) |
|
YaHookan
Join Date: Feb 2006
Location: Idaho, USA
Posts: 137
Thanks: 1
Thanked 3 Times in 2 Posts
|
I have a 50 watt hps in there and only an idiot would put anything bigger then a 75 in. And those buds arent that bad jonR my first harvest was only an eighth. I cant go any any bigger for quite a while so this will do. and now that i got shit fixed up i think itl do much better.
|
|
|
|
|
|
#40 (permalink) |
|
YaHookan
Join Date: Feb 2006
Location: Idaho, USA
Posts: 137
Thanks: 1
Thanked 3 Times in 2 Posts
|
I had to scrap the grow for security reasons. Got the cab still all set up but the plants went for a couple of days with no light in freezing temps so well see if they live. Im going to start a new grow and with bigger lights. Im thinking im going to go buy 2 dual 4 foot floros for veg and I have a 150hps for flowering. The new grow spot I have now is much more secure and a lot better for growing. How many plants do you guys think I should grow with this setup?
|
|
|
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|